ISpindel DIY Set 2600mAh

The forum of  Beer brewer (http://hobbybrauer.de/forum/) has developed a WLAN spindle.

This set consists of all components

Soldering Guide [Downlod]
Documentation [Link]

upgrade:
There will be a counted board delivered.
The board is in a very good quality.

Advantage:

1. The soldering of the board takes less than 15min.
2. Stress-free and polarity-proof assembly, thanks to the inscribed board.
3. Improved reliability by avoiding wiring errors

Technical specifications:

• Wlan capable
• Digital temperature sensor
• Position sensor
• 80 MHz Microcontroller

Content:

• 1 x MPU-6050 Module 3-Axis Gyroscope + Accelerometer Module
  • 1x Pinstrip Male angled
• 1x Resistor 220 kOhm
• 1x Resistor 390 Ohm
• 1x Resistor 4.7 kOhm
• TP4056 Charging Controller
• 1 x Mini NodeMcu Lua Modul
  
  • 2x pin strip female (long pins, 8 pins)
  • 2x pin strip female (short pins, 8 pins)
  • 2x pin strip male (8 pins)
• 1 x switch miniature angled
• 1 x Petling
• 1 x DS18B20 temperature probe
• 1x Etched board
• 1x Connector with Wire
• 1x Socket
• 1x Cable ties
• 1x battery 3.7V min. 2600mAh
• 1x printed carriage